MartinDNoa's avatar

How I made the claws of X-23 and Wolverine

By MartinDNoa
32 Favourites
6 Comments
4K Views
At the request of :iconkungfuhime2009: , I upload how did the claws of wolverine and x-23.


The material I used was white methacrylate of 0,3 mm.
I used a template made earlier in a sheet , put the template on top of the methacrylate and marked with a pen the figure. I then cut and I to sand the claws. For painting I used a silver Montana spray and for not damage the claws grip part, I used black sticky tape.


In this way, the claws don't fall from the hands and them you can open and close, and they seem that they go out of the skin.
IMAGE DETAILS
Image size
1917x840px 242.72 KB
Published:
© 2012 - 2021 MartinDNoa
Comments6
anonymous's avatar
Join the community to add your comment. Already a deviant? Log In
KungFuHime2009's avatar
Where did you get the methacrylate?
MartinDNoa's avatar
my brother brought it from Faculty of arts, I was lucky.
I don't know where you can buy there.
sorry TT__TT
KungFuHime2009's avatar
Is there a substitute you would recommend? Wood perhaps? The length, width, and thickness would be cool so i can make my own. you're are so realistic looking.
MartinDNoa's avatar
the wood, if you don't find methacrylate, could be useful, but is more flimsy and see that it's wood. but most people I know made the claws of wood, them is useful :)
OwenBicker's avatar
That's pretty sweet.
anonymous's avatar
Join the community to add your comment. Already a deviant? Log In