Engraved Wolfpony

As a birthday gift I created this little wolfpony for a good friend of mine, IceColdWulf, based on a drawing by CasyNuf. I vectorized the outlines in Inkscape and created a cut path. The end result is about 30 by 30cm large, made from 6.5mm birch wood. I could have gone larger, but I didn't want to waste too much wood. As usual, the wood was sanded and stained afterwards to give it a good finish. Thanks again at this point to AtalontheDeer for letting me use his workshop. Total work time including vectoring was roughly ten hours.