ashleytinger's avatar

23rd Century Transporter Pad and Control Booth

28 6 375 (1 Today)
By ashleytinger   |   
Published:
© 2019 - 2020 ashleytinger
My overhaul of my 23rd Century Transporter Room is done. This is specifically for a new Constitution class launching in late 2269 before the full on refit of the Enterprise would start. 

Top is the view of the control booth from the pads.
Bottom is the view from next to the booth when you first walk in the room from the corridor. 

I've got another set to upload after this. 

Built in Truespace 3.2
Rendered in DAZ Studio 4.10 with iRay
Image size
3840x4297px 2.96 MB
Comments6
anonymous's avatar
Join the community to add your comment. Already a deviant? Log In
DCJBeers's avatar
Great job!
ashleytinger's avatar
ashleytingerHobbyist Digital Artist
Thank you!
DCJBeers's avatar
Your very welcome!
SpiderTrekfan616's avatar
SpiderTrekfan616Hobbyist General Artist
I had the idea to so something similar for the Enterprise-A, the idea is to reuse as much of the original movie transporter sets as possible while also updating it to look more advanced than those seen aboard her predecessor without them looking like the TNG Transporter rooms.
ashleytinger's avatar
ashleytingerHobbyist Digital Artist
They re-used a surprising amount of parts from the TMP transporter room for the TNG set. They just didn't do a very good job of dressing it back for Trek V and VI. 
SpiderTrekfan616's avatar
SpiderTrekfan616Hobbyist General Artist
Same thing with Engineering, it was a Hasty Redress of the TWOK engine room but they didn't bother at least switching out the warp core/intermix chamber.
anonymous's avatar
Join the community to add your comment. Already a deviant? Log In